This power supply and alarm signal relay SHR CS (DIN rail mounting) isspecially designed for the new MAXIMAT leakage and overfill transmittersand liquid filling of pipes sensors CAPSYTRON SFL. It is useful with theprevious range MAXIMAT SU... and VK. It assures a continuous survey of the measurement loop, a LED indicatesthe circuit status. The alarm signal drives 2 output relays to control 2 separates systemssuch as a horn and a flashing light.

Supply power: 230 V ±10%, 50/60 Hz or 24 V DC ±10%
Power consumption: about 3 VA / 3 W
Ambient temperature: -20 to +60°C
Housing: 22.5 x 75 x 110 mm, IP 40 for standard rail per DIN EN 50 022 (35 x 7.5 mm top-hat rail)Terminals:Screw terminals, IP 20 maximum wire cross-section 2.5 mm²

Relay outputs: 2 floating changeover contacts, maximum 250 V (50/60 Hz) 3 A, or 115 V DC, 0.5 A Minimum load: 10 mA at 5V DC

Indicators:
green LED operation
green LED relay pulled in
red LED overfill/leakage alarm
red LED interrupted circuit
red LED short-circuit

Delay time: release delay adjustable from 0.3 to 3 sec

Measuring circuit:
12 V DC maximum, short circuit 110 mA
maximum inductance <5 mH
maximum capacitance < 0.5 μF maximum

Measuring cable:
300 m maximum, wire cross-section 0.5 mm² minimum

CE mark: in accordance with low-voltage directive (2006/95/EG), EMC directive (89/336/CEE) and standards EN 50 082-2: 1995, EN 55 011 (class A) 1998, EN 610010-1 1993

DIBT approval: Z-65.11-122, Z-65.13-265, Z-65.13-294,Z-65.40-201 and Z-65.40-272 for leakage and overfill detection.