 |
 Complete system (Assembly sold separately) |
Water treatment (drinkable quality water and sea water)
| Measuring parameters | : | Total chlorine (Free + combined chlorine) |
| Chlorinating agents |
:
|
Inorganic compounds additives: NaOCl; Ca(OCL)₂;
gaseous chlorine; chlorine produced by electrolysis
Surfactants: partial tolerance
|
| Measuring system | : | Closed cell with 3 electrodes and electrolyte |
| Output signal |
:
|
4 ... 20mA, 2-wire, screw connectors (2 x 1mm²)
No galvanic insulation
|
| Operating temperature |
:
|
1 ... 45 °C
Automatic temperature compensation
|
| Operating pressure |
:
|
0.5 bar max. (without securing collar)
3 bar (with securing collar)
No vibrations, no pulsating flow
|
| Flow rate | : | About 30 l/h |
| Supply voltage | : | 12 ... 30 V DC; Load: 500 to 900 Ω |
| pH operating range | : | pH 4 to pH 12 (low incidence of pH) |
| Conductivity | : | From 10 μS/cm up to 50 mS/cm (sea-water) |
| Interferences | : | Incidence of ClO₂ and O₃ on measuring signa |
| Zero adjustment | : | Not necessary (from factory) |
| Slope calibration | : | Through 1 point (slope), with BAMOPHAR 194 (DPD 4) |
| Materials | : | PVC-U; PEEK, AISI 316 Ti |
| Dimensions | : | O.D. 25mm, length 220mm (4-20mA model) |
| Code | Reference | Measuring range | Resolution |
| 193 047 | CP4.MA2 | 0.005 ... 2 mg /l | 0.001 mg /l |
| 193 048 | CP4.MA5 | 0.01 ... 5 mg /l | 0.01 mg /l |
| 193 049 | CP4.M10 | 0.01 ... 10 mg /l | 0.01 mg /l |
| Replacements | |||
| 193 915 | M48.4E | Sensor end with diaphragm (not for sea-water) | |
| 193 xxx | M48.4S | Sensor end with diaphragm for sea-water | |
| 193 964 | ECP1.4/GEL | Electrolyte for sea-water | |
