An extension terminal (wall, panel mounting):

- Allows a second measurement parameter (pH, Conductivity, dissolved Oxygen, Turbidity, Flow, and any 4-20 mA, depending of the model)
- Data from this blind BAMOPHOX are displayed on the main device on the second line display).
- A 4 wires shielded cable is necessary to link both instruments (maximum length of 500 m)

The BAMOPHOX 192 is specially designed for monitoring swimming pool and spa waters and also for drinkable waters.
It offers high flexibility on use mixing different built-in programmes for regulation, thresholds, temperature compensation, and alarms. The 2 lines back lighted display, 16 alphanumerical characters, gives an easy measurement and temperature reading in any conditions. It also displays the configuration menu and settings of thresholds, analogical outputs, operation data modes. To allow a quick and easy diagnostic after configuration a simulation program is built-in with direct actuation on contacts outputs, and analogical outputs. The output signal of 4-20 mA output is galvanic insulated; it can be set up within all scales of the parameter. Temperature measurement is also available on a 4-20 mA output ; this output is useless when PID regulation is in function.

Displayed parameters: Measurement values of free chlorine concentration - Configuration Menu - Temperature value
Display: Back lighted - 2 lines of 16 alphanumerical characters ; 9,2 mm high
Indication: LED alarms status
Configuration: 8 push buttons keyboard on front face - Keyword protected

Range:
0 to 5 mg/l [0...5 ppm]
Accuracy±0.3% of the scale

Temperature input: For a 3 wires Pt 100 Ω /0°C; accuracy ±0.3°C if a convenient probe is used.

Relay outputs:
4 closing contacts (Silver alloy), voltage free
3 programmable independent thresholds - with adjustable hysteresis 0…100% - and adjustable timer from 0 to 9999 sec

1 Output relay (S4) as a common alarm for:
- open loop
- Pt 100 Ω dysfunction

Contact: Switching capacity 250 V / 3A AC, 30 V / 3A DC, minimum 100 mA / 5 V DC
ON/OFF Regulation: Pulse time 0…9999 sec - High and low proportional bandwidth, high and low dead zone.
PID Regulation: Proportionality 0…200% - Integrant and Derivative 0…999 second
Calibration sequence: Relay outputs inhibited, analogical outputs stand on last values
Measurement output: 0/4-20 mA (maxi 600 ?) proportional to measurement, galvanic insulated
Temperature output: 0/4-20 mA (max 600 ?), range -20…+160°C ±0.3°C, galvanic insulated
Main power supply: 230 V AC / 50-60 Hz [other on request] - Consumption 10 VA

Models:
Panel mounting, front IP65, 72 x 144 mm, connections on screw terminal IP40
Wall mounting, IP65, cable glands, connections on screw terminal