With its integrated transmitter and connection for diagnostic, the MAXIMAT isideal to detect the presence of a liquid due to a leakage from dangerous andnon-flammable liquids containers.

The transmitter MAXIMAT is designed to detect conductive liquids with aresistivity up to 5 kOhm/cm and a coupling capacitance towards ground ofmore than 50 pF. The liquids may not generate electrical insulating orconductive deposit.
The MAXIMAT has 3 different outputs, factory built-in:

• Binary output to active optocoupler, numeric input
• Analog 0...20 mA output for any analog input of PLC

Main power supply: 15 ... 26 V DC; caution: DC current circuit shouldbeprotected by a fuse of 250 mA. Power consumption: approx. 3 W
Ambient temperature: -20 to +60°C
Operating pressure: atmospheric, 0.8 to 1.1 bar

Sensor tube:
PE-HD material (MAXIMAT LWC..),
PVC material (MAXIMAT LWC25)

Terminal housing: PBT, fibre glass reinforced, IP 65 acc. EN 60 529
Terminals: screw connectors, IP 20; max. wire cross-section 2.5mm²

Cable 6 m long:
PCV, shielded, 7x0,5 mm2,(MAXIMAT LWC..)
PCV, shielded, 7x0,34 mm2,(MAXIMAT LWC25)

Hysteresis: About 2 mmSwitching height:5 mm as the minimum

Outputs:
      • Switch [+DO / -DO]:optocoupler NPN, maximum 30 mA
      • Switch [+AO / -AO]:current 0...20 mA

Configuration: with 4 DIP switches
Lighting signal: 1 LED inside the terminal housing for correct operating system

CE mark: in accordance with low-voltage directive (73/23/EWG) and EMC directives (89/336/EWG) and standards EN 50 082-2 : 1995,EN 55 011 (class A) : 1998

Approvals: DIBT Z-65.40-316, for overfillingand leakage detection WHG§19